Thermal target Pulsar – 1 piece

Description

Description of Pulsar thermal target – 1 piece

Please follow 10 steps to successfully use heated targets:

The heat pack is air activated, do not open the pad package until you are ready to use it.
Open the package and remove the heat pad.
Note! Do not cut or damage the heat pad while removing it.
Remove the paper tape from the back of the heating pad to expose the adhesive surface.
Stick the heat pad with the sticky side to the center of the paper target marked with a circle.
Note! No need to shake the heating pad, it will heat up in 3-5 minutes.
Attach the paper target to the desired location.
Aim at the heated pad with a thermal imaging scope mounted on the firearm and optimize the thermal sight so that the thermal pad is clearly visible.
Perform a reset procedure as described in the user manual of your thermal imaging device.
With the help of the round shape and small diameter of the pad, deviations in the point of impact can be eliminated in just a few shots.

Active Heat Pack Specifications:
Quantity in box:

– 10 pcs. paper size: 30 x 30 cm

– 10 pcs. charcoal activated heating pads with adhesive side: 40 mm (heated surface)

Duration of pad staying hot: 10-20 minutes, on cold surfaces (depends on weather conditions)

Ingredients: iron powder, activated carbon, vermiculite, salt, resin, water